霍尔效应传感器

Good morning, it is the first time I write in this forum, I need your valuous help, if someone can guide me it is this problem, I have a 92 1.8 liter 4-cylinder model, which does not start because the current does not reach the hall sensor, which has an harness of 3 terminals which are land-pole-corner, the current cable goes directly to the computer in the pin number 8 according to the diagram of the number 8 Digifan II, my question is whether the computer is the one that must send传感器的电压，反之亦然？我澄清说，当您将电池直接电压放置时，汽车启动时，请毫无问题，非常感谢您提供的信息，问候

您有进入霍尔传感器的 +进入传感器，并且在中介质的电缆通常会发出信号，通常会在禁令系统上的电子或总机<-Depebere。

该模块将向线圈发送负，并将线圈放大。

如果您按照说明，则总机应将其发送到当前 +传感器。

这就是伊格里（Igryo）说的话，如果没有计算机的迹象。

您通常有12个参考伏特，5伏输入信号和返回PCM的信号，但只能使用示波器设置此文章来检查该主题的本文www.autoavance.co/blog-tecnico-tecnico-automotmotmotri...olocity-effect-felfect-hall-hall-hall-hall-hall