Fucking crap, it does not come out

Greetings to all here.
I am complicated to get a crankshaft from a ga16 -engine Nissan, it is locked just where the axials or croissants go in the center of it, I do not want to apply brute strength not to fuck it. And that has already applied quite strength.
some suggestion please.

Take a blow back and another, and then to the counterweights of rest 2 and 4 down, it should release

You must release all the connecting rod benches and piston, and then as EcTor says to give him some tap to loosen, if he does not come out you will have to apply brute force you have to take it out anyway to see what happens.

Thanks for taking the time to answer.
I tell you this engine, a friend was putting a friend out what happened is that when the rectified crankshaft put, with rod bearings, bench and axials new. Apparently when the axials put it out they left their place and according to him as the crankshaft cost, he did it by pressing with the tapas. Problem the crankshaft placed does not turn, and now it does not come out either. It is more tight than the Damper bolt, hahaha.

hahahahaha