Search in MDM

Bulletin

Check me the manual you need

  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
17 years 7 months before #2259 by manual-mecanica
Manual-Mecanica Response on the Re: Build me the manual you need
Look I have a porblema with my car is a Astra 2001 Comfort 1.8 and I am marking a mechanical failure according to it and I mention that it is a sensor the TPS I do not know where it is located I would like you to help me to locate this sensor since I meant me that you have to remove and clean it because of the best it can help me to locate this sensor thank you
The theme has been closed.
  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
17 years 7 months before #2260 by manual-mecanica
Manual-Mecanica Response on the Re: Build me the manual you need
Can you help me get the 2001 Astra Manual, I will thank you
The theme has been closed.
  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
17 years 7 months before #2281 by manual-mecanica
Manual-Mecanica Response on the Re: Build me the manual you need
Hello, the Opel Frontera Workshop Manual would need 2.8 TD
The theme has been closed.
  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
17 years 7 months before #2301 by manual-mecanica
Manual-Mecanica Response on the Re: Build me the manual you need
: Cheer: Hello, I need the Ford Windstar Gl 96 manual, I hope you can help me, thank you !!!
The theme has been closed.
  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
17 years 7 months before #2305 by manual-mecanica
Manual-Mecanica Response on the Re: Build me the manual you need
Hello!

You see, I have a Peugeot 206cc and I need to disassemble the steering wheel; I have found a manual of how to do it, but when I have gone to screw the Torx30 that the steering wheel should have, I have realized that the steering wheel does not have these screws from behind: it only has a hole in the lower part of the central arm, and it has no screw, but a kind of little tight is seen inside, and I do not know if you should do lever on it.

Do you have any idea how I can disassemble it?

Thank you very much for your help
The theme has been closed.