Chevrolett Aveo Codes 2004 (P0351-P0353)

Change the cousin coil !!!!!!!!!!!!!!! I do not know what country you are, but it is the same that the Chevrolet Optra occupies, the Corsa, and the Chevy (Mexico) is the same coil, all the spark plugs will launch spark, but not with the necessary power, it reviews the resistance of the terminals that go to the spark plugs, 1-4 and 2-3 I think it was like that, but check the coil there are marked, they are marked. If the resistance varies a lot between the two resistors your coil is damaged, but according to your diagnosis for the codes shown, the problem is in the primary coil, I already lost its properties, change the coil, put a test and you will see the result ...

Thank you, greetings from El Salvador, I will try the coil then comment as it went.

OBDII CODE LIST> P0351
P0351

P0351 - Ignition coil 'A' Primary/Secondary Circuit Malfunction

1
0 Comments | Add Comment
Symptoms
- Engine Light On (OR SERVICE SOON WARNING LIGHT)
- LACK/LOSS OF POWER

-
ENGINE MAY BE HART TO START -

ENGINE HESITATION
- ROUGH ENI
LOB Electrical Connection - Faulty Ignion Coil Primary/Secondary
- Faulty Engine Control Module (ECM)
When is the code detected?
The Fails When the Engine Control Module (ECM) does notice Valid Pulse Signal from the ignition coil.
P0351 Description
The Ignition Signal From The Engine Control Module (Ecm) is feeling by the power transistor. The Power Transistor Turns On and off the ignition coil primary circuit. This on/off operation induces the proper high voltage in the coil secondary circuit.

Enter register

Q & A
TSB
OBDII Articles
OBDII CODES
LIST OF CODES OBDII> P0353
P0353

P0353 - COBINA 'C' MALL FUND OF THE PRIMARY / SECONDARY CIRCUIT

1
0 COMMENTS | Add comment
The symptoms
- Light motor (or motor service light soon warning)
- Missing / loss of energy
- engine can be more difficult to start
- engine hesitation

Gruto -idle engine
between
possible
causes Primary / secondary ignition coil
harness of the control module engine (ECM)
when the code is detected?
The test fails when the motor control module (ECM) does not receive a valid pulse signal of the ignition coil.
P0353 DESCRIPTION
The ignition signal of the motor control module (ECM) is sent and amplified by the power transistor. The active power transistor and the circuit of the primary coil of ignition is deactivated. This ON / OFF operation induces the high voltage in the secondary coil circuit.
¿

This type of coils is very common that Fayen may be that the problem is that it is too weakened the spark and the best scheme does not buy one in print because a client of mine bought a there and then I claim because it lasted only 15 days after verifying that this coil was bad I made it buy one in Didea at the end for wanting to scare a little more expensive greetings to you also from you also from the savior