FAILURE IN HYDRAULIC ADDRESS GRAN CARAVAN 96

Hello, how do you want everyone
to know if someone can help me with the doubt of a fault that began to make my Grand Caravan 96 truck yesterday, it turns out that yesterday the steering wheel began to be tough and when the chest opened, I noticed that by the deposit of the direction to be exact by the plug., I was fusing the oil of the direction, I shot a good section where the pressure was lost. I add and when starting it, it worked perfectly well without noise, and soft, the thing was right now to do some things and started sounding and from time to the house it was already noticed that it was getting hard again, the thing schensted it for a while and it works well, and then as an hour it starts to fail again.
If anyone knows anything about this fault please do not leave me hung with the answer.
Greetings and thanks ...

Hello, it turns out that my truck after conducting it for approximately the direction is heard a buzz and expels the oil by the deposit, to the degree of locking the direction, I have to stop and turn off the engine, when uncovering the plug of the liquid deposit it shows that it is bubbling and suddenly the problem is corrected but in a very momentary way, this is generally Pronounced curve, I will appreciate your comments, thank you.

Foebden wrote: Hello, how did everyone
like to know if someone can help me with the doubt of a fault that began to make my Grand Caravan 96 truck, it turns out that yesterday the steering wheel began to be tough and when the chest opened, I noticed that by the deposit of the address to be exact by the plug The level marked minimal did not add it and when it started it worked perfectly well without noise, and soft, the thing scheduled I went to do some things and started sounding and from a while already arriving at the house it was already noticed that it was getting hard again, the thing schensted it for a while and works well, and then as an hour it starts again to fail.
If anyone knows anything about this fault please do not leave me hung with the answer.
Greetings and thanks ...

It may be that the direction pump is about to be damaged due to some escape or for the time since it is mostly the only thing that gives noise and makes the steering wheel hard, because as long as it has a liquid above the minimum it should not sound or get tough it only pass those failures when the hydraulic pump is damaged

The noise comes from the pump cavitation, this basicamante are air bubbles that explode. The pump can cavitate for two reasons, or for internal leaks or by Danio in the suction hose. (The one that goes from the deposit to the pump, of more diameter). Make sure this duct is fine, it can be dry and not lose and yet to enter air. It can also be that the air enters through the pump axis retain. In short, check these things, put the deposit and give the top address to both side until the system is purged.