Search in MDM

Bulletin

It is hard to put the 1st speed

  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
16 years 9 months before #4410 by manual-mecanica
Manual-Mecanica response on the Re: it costs to put the 1st speed
hello! For me the problem is still in the clutch, take it to the workshop and check it back. If you changed it you look if if the car begins to come out when you release the pedal and it is in the middle of the route.

Please connect or create account to join the conversation.

  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
16 years 9 months before #4415 by manual-mecanica
Manual-Mecanica response on the Re: it costs to put the 1st speed
Thanks for your response but the problem was not the clutch as Leoperello and Llolleo said simply as Migueltfs was the rod that had not adjusted it well, it was poorly regulated a little patience and fixed the problem. I thank you again for your speed to answer me: Lol:
Greetings

Please connect or create account to join the conversation.

  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
16 years 9 months before #4573 by manual-mecanica
Manual-Mecanica response on the Re: it costs to put the 1st speed
Hello.
Before checking the clutch, which under my criteria I do not think is bad since it has not been shot, and it is new, I would check, apart from the regulation of the rod, which has a lot to do with the symptom, it is the rear motor, or connecting rear support, or connecting, which is called, and also that the change support is tight, and fixing you in the mark that leaves the screws, which is more or less in the same position as before.
Greetings to all.

Please connect or create account to join the conversation.

  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
16 years 8 months before #4618 by manual-mecanica
Manual-Mecanica response on the Re: it costs to put the 1st speed
Hello friend, give a little more route to the clutch and fix if when you connected the lever it was fine in the center of the dead point, if not disconnect it and go back to connect, whatever you hold it from it from the car

Please connect or create account to join the conversation.