I have injection problems Stratus 2.4 Turvo

Good afternoon friends I have no pulsation in injectors to any sensor or it is the same computer that presses at the beginning works the injector 1 and 3 that could be because I am already desperate. The injectors arrives Corriete 12 volt. It continues or is the earth because I do not know that cable is the one that gives pulsation according to what you know is that the earth has to press and it is the opposite the Earth this static does not varea. I hope you can help me greasia greetings

The common of these sitema works with the negative as a successor, if you work 1 and 3 what you can do is make a bridge between the cable of the 1 and four, also with the two and the three, if there are no pulsations the most common is that the computer is failing, although there is always the possibility that the problem is in the wiring or connectors from the computer to the main connector that reaches it, the moisture makes the moisture.

Hi Kikemec Greetings of Hicho served me your Tip Afi to check all those points by reading the conclusion that CKP Abesses Work and Avees No, as it is not explained but that was the problem of this Stratus in advance Grasias for your observations served me much. In this case I repeat was the CKP the problem, this CKP handles two injection things and food coil.

Ok thanks for putting the solution of your problem as you say you are rare, since in general that sensor fails and fails does not make it intermittent. thank you,