Ford Ka does not turn on

Manual-Mecanica
Author of the subject
Offline
Fresh Boarder

Further

13 years 10 months before #24150 by manual-mecanica

Ford Ka does not turn on published by Manual-Mecanica

I have Ford Ka 1.6 that does not turn on. The lights work, alarm. The coil was changed since it was short and the board fuse had burned the engine but not pulse. The Scaner does not indicate any failure. Please have any help since I provide with everything and I can't find the fault. Thank you.

Please connect or create account to join the conversation.

Manual-Mecanica
Author of the subject
Offline
Fresh Boarder

Further

13 years 10 months before #24157 by manual-mecanica

Manual-Mecanica response on the Re: Ford Ka does not turn on

Check the crankshaft captor is in charge of sending the spark signal, and Claro Checa that exists the spark in the spark plug cables.

Please connect or create account to join the conversation.

Manual-Mecanica
Author of the subject
Offline
Fresh Boarder

Further

13 years 10 months before #24159 by manual-mecanica

Manual-Mecanica response on the Re: Ford Ka does not turn on

If you refer to the wheel, take it out and test it and go ok. Current arrives by the two channels but there is no sign on the central channel. At the moment Kemados is not the emergency Blokeo system this OK. They turn on lights and board the Scaner does not detect any fault. I don't know what to do .....

Please connect or create account to join the conversation.

Manual-Mecanica
Author of the subject
Offline
Fresh Boarder

Further

13 years 10 months before #24171 by manual-mecanica

Manual-Mecanica response on the Re: Ford Ka does not turn on

But if there is no sign on the middle channel then it is not right, I am referring to the magnet captor connector.

Please connect or create account to join the conversation.

Manual-Mecanica
Author of the subject
Offline
Fresh Boarder

Further

13 years 10 months before #24173 by manual-mecanica

Manual-Mecanica response on the Re: Ford Ka does not turn on

Friend, check the pump, if you have a spark, the signal of the captor with an oscilloscope, but if you say that it does not send pulses the problem can be in the ECU

Please connect or create account to join the conversation.