Renult 19 starter engine

Hello everyone: Can someone tell me how can I remove the starter engine to check it?
The truth is that I like to get personally solve mechanical problems.

Thanks from now

In the workshop manual section you have the explodes of the R19, lower it and look at it, but I think it will not be very complicated, luck

Thank you for your emerald contribution, already lower it, now to the practical part, we will see that it results.

Tell me the engine that carries the 19 and I tell you how it is removed, because it is not exactly the same in all models but it also indicates the things that must always be taken into account:

the first thing to disconnect the mass of the battery to avoid unpleasant surprises, then locate the position of the starter engine in the car and remove the cable from the direct battery positive that reaches one of the screws of the starting relay (30)

later positive contact key (51) of the starting relay.

And finally you proceed to loosen the screws that bind it to the clutch envelope of the gearbox (two or three large screws) and sometimes some other smaller screw that carries behind.

All the best.

Ok, well it is 1.6 Bencinero year 1999, so far a jewel, the truth is that its location is very difficult, try it below, but apparently you have to take the multiple, since the carburetor is above, isn't it?

Thanks from yab)