Normal fat difference and for homocine Board

As they are vacations and already has a good one to check the tales that I proceed to disassemble to verify and it turns out that since I had no other fat at hand I put grease for homocinetic joint of which he has graphite to the bearings (shines) my doubt enters because the fat I had was greenish there will be some anger ????


I thank you in advance for your answers

Look at the bearing fat versus the fat of the homsinetic is different, but more at the point of toleransia at temperature and chemical characteristics, the best is red or green for bearings since the friction is a lot, but anyway it is better to have any type of fat to which they do not have hahaha, change it for safety for safety laundering the bearing with the bearing and put the new fat, do not do it. You leave the same one works but you decrease the useful life nothing more.

Thanks Kikemec right now I'm going to buy the other fat to change the fat to the beal.

For that we are friend, no problem.