Electric Circuit ECU-SENSORS, GOL 1.9 SD 2000

Hello Friends of the Forum, I am needing the Ecu-Sensors Electrical Circuit, 1.9 SD 2000 goal, the problem is that the engine smokes between 1200-2000 rpm, detects measuring the tension in the pump that advances before the indicated (it should be progressive) but at 1500 rpm it is in 10-11v, if someone has an idea I have
the
circuit

Good. For not made smoke, but due to lack of progress, yes, it pulls white-blue smoke. If you control the pump point with a comparator clock, from the beginning of the Ram disc movement (0.90mm +-9) considering PMS.
Another: look at the EGR is not breaking the balls. Another: that does not reach the pump well and does not let the hydraulic advance work.Cambia filter and torch pipe

Below the pump it carries an electric advance that is controlled by the switchboard and the temperature censor of the cooling D four PIN. Disconnect the topic censor to see some change. At this time I am not in the workshop and I do not remember how to test it. Good luck and do not forget to publish how it went

Thank you San for answering, it may be that it lacks progress, so it makes that make it between 1500-2000 rpm, I disconnect the tab of said progress and the engine works perfect, without any problem, so I think there is some cut cable, or sensor, central that is not working well, the large tab in the engine butt is fine, it would have to see which are the ones that reach the central and test them, so I want the diagram. Firefighter say there is no problem in the bomb, take it to the electrician and they told me that it was the bomb?